Advertisement
@ POWER switch (ON/STANDBY)
@ Cassette holder (deck A)
© Cassette operation buttons (deck A)
«<
: Press to wind the tape quickly from
right to left.
>>
: Press to wind the tape quickly from
left to right.
Wi (stop)
: Press to stop the tape.
PLAY
: Press to play the tape.
4) direction: Press to change the direction of
tape travel.
@ 'A (eject) button (deck A)
@ Power STANDBY indicator
Lights when in the power standby mode.
© COUNTER RESET button (deck A)
Press this button to set the digital counter to "O000".
Even if the POWER
switch is set to STANDBY,
the
counter value at that time is stored in memory.
@ Indicators
@
DDRP indicator
@)
Peak level indicator
These indicators light according to the level of the
signal being recorded or the level of the signal
recorded on the tape.
Note:
0 dB: IEC (DIN) STANDARD LEVEL (250 nWb/m)
0 VU: Signal level at 160 nWb/m
00 : DOLBY NR STANDARD LEVEL
3) HX PRO indicator
@)
Digital counter
The counter reading increases while the tape is
running forward and decreases when it is running in
reverse.
() Mechanism mode indicators (Deck A)
>>
: This lights when winding the tape from
left to right.
«<<
: This lights when winding the tape from
right to left.
Pama
PLAY
: This lights when in the playback.
«>
: Indicates the direction of tape travel.
©
DUBBING : "" lights when the normal-speed
dubbing mode.
"»" lights when
in the high-speed
dubbing mode.
@
CONT
: Lights when the unit is continuous play
mode.
Mechanism mode indicators (Deck B)
PLAY
: Lights when the unit is in the playback
and record modes.
<>
: Indicates the direction of tape travel.
REC
: Lights when the unit is in the record
and
record-pause
modes;
blinks
during record muting.
Tf
: Pause indicator
>>
: This lights when winding the tape from
left to right.
<<
: This lights when winding the tape from
right to left.
@
cx
: Indicates reverse mode.
© COUNTER RESET button (deck B)
© A (eject) button (deck B)
@ Cassette holder (deck B)
@ DOLBY NR switch
Set to B or C for recording using the Dolby NR system or
for playing back a tape that was recorded using the Dolby
NR system.
Set to OFF when the Dolby NR system is not used.
@ REVERSE MODE switch
Select the single side or full record/playback mode, or the
continuous play mode.
yaa
: For single-side recording or playback.
2
: To play or record both sides A and B.
co)
: To play sides A and B continuously.
@ PHONES jack
Connect headphones
(with an impedance of 8 Q to
1 kQ).
(No. 4357) 9
Advertisement
