Machine Operation; Tool Post Setting - Mirage MM305i Operation & Maintenance Manual

Machine Operation

8.
Note: No machine adjustments should be made while the machine is in operation. Turn the
pneumatic supply off before making any adjustments.

Tool Post Setting

To adjust the angle of the tool post, release the two M8 locking bolts ½ - 1 turn each and move the
tool post to the desired position.
M8 Locking
Bolts
To alter the depth of cut, first make sure that the locking screws are not tight and turn the hand
wheel. When viewed from above turning the hand wheel clockwise will feed the tool downwards.
Turning the handwheel anti-clockwise will feed the tool upwards.
To alter the depth of cut, first make sure that the locking screws are not tight and turn the hand
wheel. When viewed from above turning the hand wheel clockwise will feed the tool downwards.
Turning the tool anti-clockwise will feed the tool upwards.
When the tool is correctly positioned re-tighten the 'Locking Screws'.
Tool Locking
Screws
Doc: MML265 Issue: 004 Issue Date: 13.06.2013
Mirage Machines Ltd ∙ 8-10 Enterprise Way ∙ Derby ∙ DE21 4BB ∙ UK ∙ t: +44 (0)1332 291767 Page 26 of 39
f: +44 (0)1332 370356 ∙ sales@miragemachines.com ∙ www.miragemachines.com