Table of Contents
Advertisement
34
EN
Before requesting service for a problem, use this chart and see if you can repair the trouble yourself. Small problems are often easily
corrected, and this can save you the trouble of sending your video recorder off for repair.
PO W ER
SYM PTOM
1. No power is applied to the
recorder.
2. The clock is functioning properly,
but the recorder cannot be
powered.
3. The remote control won't function.
TAPE TRAN SPO RT
SYM PTOM
1. The tape does not run during
recording.
2. The tape will not rewind or fast-
forward.
PLAYBACK
SYM PTOM
1. The playback picture does not
appear while the tape is running.
2. Noise appears during visual
search.
3. Noise appears during normal
playback.
4. Noise appears during slow-motion
playback.
5. Noise appears during still
playback.
6. The playback picture is blurred or
interrupted while TV broadcasts
are clear.
7. Playback picture has a loss of
colour.
8. No sound accompanies the
playback picture.
Downloaded from:
https://www.usersmanualguide.com/
POSSIBLE CAUSE
● The mains power cord is discon-
nected.
● " ‰ " is displayed on the display panel
with Auto Timer set to "OFF".
● The batteries are discharged.
POSSIBLE CAUSE
● " " is displayed on the display
panel.
● The tape is already fully rewound or
fast-forwarded.
POSSIBLE CAUSE
● If you're using the RF OUT connec-
tion . . .
. . . the TV receiver's channel selector
is not set to the VIDEO channel.
. . . the recorder's VIDEO channel
has not been correctly set.
● If you're using the AV connection, the
TV receiver is not set to the AV mode.
● This is normal.
● The automatic tracking mode is
engaged.
● The automatic tracking mode is
engaged.
● The video heads may be dirty.
● The wrong colour system is selected
for the tape being played back.
● The wrong colour system was
selected during recording.
● The TV system you have selected at
the TV System Select screen is
incorrect.
TRO U BLESH O O TIN G
CORRECTIVE ACTION
Connect the mains power cord.
Press the TIM ER button to turn the " ‰ "
indicator off.
Replace the dead batteries with new ones.
CORRECTIVE ACTION
Press PLAY to turn the " " indicator
off.
Check the cassette.
CORRECTIVE ACTION
If you are using the RF OUT connec-
tion . . .
. . . set the TV receiver to the VIDEO
channel. (
pg. 4)
. . . Perform "Video Channel Set"
(
pg. 4)
If you are using the AV connection,
set the TV to its AV mode.
Try manual tracking. (
pg. 13)
Try manual tracking. (
pg. 13)
Press TV PROG + or – a few times to
remove the noise bars from the screen.
Consult your J VC dealer.
Select the correct colour system by
pressing the CO LO U R SYSTEM
button. (
pg. 28)
Once recorded, the signal cannot be
corrected. Be sure to choose the
correct setting before recording.
Set it to the correct position for the TV
broadcast system used in your area.
(
pg. 33)
Advertisement
Table of Contents
