Table of Contents
Advertisement
TROUBLESHOOTING
to carry out repair work.
No power supplied to unit.
© Power plug is disconnected from outlet.
¢ The component power plug has been plugged
into another component power outlet (e.g. timer,
etc.) but power to that unit is disconnected.
¢ POWER STANDBY/ON
switch is set to
STANDBY.
¢ Connecting cords are disconnected from
terminals, or connected incorrectly.
¢ Terminals, or connecting cords pin plugs are
dirty.
e INPUT SELECTOR button is not set to the
desired input source.
¢ Insert plug securely into outlet.
© Turn on power to the other component.
* Press the POWER STANDBY/ON
switch to ON.
¢ Connect securely.
e Clean terminals and plugs.
© Set the INPUT SELECTOR button correctly
(PHONO, TUNER, CD, LINE, TAPE 1/DAT,
TAPE 2/ADPT).
© Consult the operating instructions for the other
- components.
© Set one button or both buttons to ON (am).
© Operation of other components is incorrect.
¢ Both SPEAKERS selector buttons are set to
OFF (#L).
No sound from one speaker.
¢ Connecting cords or speaker cords are
® Connect securely.
disconnected on that side.
Cannot record tapes.
® Connections are incorrect.
* Reconnect properly.
® Operation of cassette deck is incorrect.
¢ Consult the operating instructions for the
Cannot perform tape copying.
cassette deck.
The remote control unit does
¢ Operation of cassette deck is incorrect.
¢ Consult the operating instructions for the
cassette deck.
not work. (Other components
¢ There are no batteries in the remote control unit.
| ¢ Load the remote control unit with batteries
cannot be operated.)
(see page 9).
* Operate the remote control unit within a range
of 7 meters and an angle of 30 degrees (refer to
page 9).
e Check that the battery compartment cover is
closed correctly.
¢ Connect correctly (see page 7).
¢ Move so fluorescent light does not shine directly
on amplifier front panel remote sensor window.
* The remote control sensor is not receiving any
signals.
¢ The battery compartment cover is not perfectly
closed.
¢ The remote control cord is not connected.
¢ A fluorescent light is shining on the remote
sensor window.
11
<ARB1355>
Advertisement
Table of Contents
