Alpine TDA7556R Service Manual page 58

GR-S
SERIES
Disassembly, Assembly and Replacement of Functional Parts
HERE BB da 5) B e FAIL RURAL
1. Disassembly and Assembly of Bottom Cover
(7) Turn the mechanism around as shown in Figure 1.
(2) Remove three screws () as shown in Figure 1.
(3) Lift the bottom cover slowly from the position A-1, pull the hooks out of the holes in the chassis, and remove
the bottom cover as shown in Figure 1.
(4) Set the mechanism to pack down status and place the mode lever to the position shown in Figure 2-1.
(5) Press the metal switch lever in direction shown by the arrow (refer to Figure 2-2), insert the pinion sub motor
shaft to the pinion sub motor hook hole, and insert the chassis engagement claws into the chassis engagement
holes. (Check to see the sub motor wire is placed in the normal guide position of B section.)
(6) Rotate the pinion sub motor counterclockwise after insertion of the bottom cover, and check to see the end
place of A section in Figure 2 is closely touched. (refer to Figure 3)
(7) Fix the screws that have been removed.
NOTE : @ When fixing the bottom cover, be careful to avoid
damage by the beit.
@) Fasten the three screws with a fastening torque of 6 kg.cm.
1. KELAN-ODRABRVOMULAR
(1) XHERRLICLET, (Miss)
(2) 3BDRAVOCHALET, (Missa)
(3) A-1BP SRE LAN-EMDSUERBHL,
DURILORABEAL,
PRUETT.
(MiShe)
(4) MAUZNR IE, ADEN y TDOWNARBBIC UT. E- KU N-OMBEM21OMBICS beet,
(6) XZWSWEN-ERM AM (M2-26R8)
(CHL. SUB MOTORRARESUB MOTORBIRARICHA L.
Ye
LORAYA EY -— YL -—REARIHALET.
KCK KLAN-(REBERT.
(LOM, FAE-2-TI(V—-PBRBEMAT FMBCHST SE)
(6) RK LAN—(RRBESUBMOTOREAZRYICEL,
M2ARHEY
DS +-—VLeRRMLECCERBLET.
(B13 F8)
(7) DRRIRICALERYVEILOET,
[ER] © AIRF, SIL RICRER UE URRICIERL TF AU,
@ 3KDAVlS6kgcmO hILD CHOU TF AU,
'
Bottom Cover
Figuer 1
-~12-