Alpine TDA7556R Service Manual page 65

| GR-S
SERIES
c. Disassembly and assembly of the cassette holder
(1) Remove four screws @ and remove the eject frame assembly and the frame holder as shown in Figure 11.
(2) Remove M1.2 lock washer 4 and plate base roller (@ and remove the cassette holder and the base plate
assembly as shown in Figure 11.
(3) Remount them following the removal steps in the reverse order.
NOTE : © When mounting the cassette holder and the base plate, insert the slider shaft into the eject arm and
fix them turning the slider shaft in the direction indcated by the arrow in the figure . Make sure that
the cassette holder and the base plate are in the cassette-in mode during this operation.
(Refer to Figure 12)
@® When mounting the eject frame assembly, push the auto metal lever in the direction indicated by
the arrow in the Figure 11.
@ When mounting the base plate assembly and the eject frame assembly, or when mounting the eject
frame assembly to the chassis, do not apply excessive force to avoid deformations of the eject arm
and the frame.
@ Do not reuse the used washers. Take care to avoid damage by piercing and tearing.
@ Fasten the two screws 4-1 with a fastening torque of 6kg.cm. and the two screws ()-2 with a
fastening torque of 1.5kg.cm.
c. Atky khAULA-OPRMARRVGLAER
(1) 4EORVOEAL TVLTFAKIL-LAWRUIL-ARWAZ-EKALETF. (R118)
(2) By 7Dyvy4—@® (M12) EAL—bN-ZD—-F—-OEAL, ALY hARVHA-ENXN-ZRIL— AW
CALE, (11S)
(3) PRMAAKCMOFMCRUWIET.
[ER] OAty hAUH-EN-ATL— hRUEMAL CSR, ZF F-OYvThETY IT
P-AICHAL,. PORIRUA AULEPSRUAUVET, COMAtKY KAWH-EN-Z
TFe-—htAtyhKTL-ORMBCHITE, (M12BRR)
QIvVrFhIv—-AMUMEYy—-Y—-KRUAU SR, F-bABWUN-€EMORKRAAMC
HUTA, (21188)
@N-ASFL-—hMBILET YI ARIL-AMIERMY MWS. Ro ver-y-eEfyxr7k
JL—AMIZERUAU SRS, BDELUEOHDEMAZABUEFAUW, (TF VILATKP—-A,
7FL-LOBRBMILDA)
@-B@RLEDTy y—lt., @RAULEUTE, M. OM. OK NOZUTE,
® RVO-1lt6kgem, -2t15kgomM hILVTCHORUSTZE,
Eject arm
b
Slider
Figure 12
Pinch roller
-19-