Function And Features; Profibus-Dp Interface; Installation - IFM Electronic AS-Interface AS-i ControllerE AC1365 Installation Instructions Manual

Function and features

• The controller
both in accordance with the AS-i version 3.0), a mini controller and a
Profibus DP interface (optional)
• It controls the exchange of data to the sensor/actuator level
• processes the peripheral data in the integrated processor (signal pre-
processing)
• works as stand-alone controller with exchange of data to the PC
(visualisation)
• communicates with the higher control level (in the gateway mode)
Programming interface RS232C
• Baud rate 4800 to 115,200 baud
• Max. distance between controller
• Potential separation from the controller
• Programming cable E70320 for connection to PC required

Profibus-DP interface

• Baud rate 9600 to 12 MBaud
• Max. distance between controller
the baud rate
• Potential separation from the controller
• Up to 31 controllers connected in parallel per segment
• Pin connection: pin 3: signal B, pin 8: signal A

Installation

Fix the controller
und connection. The protection rating of the unit is IP20, therefore it
should be mounted in a protected location (e.g. control cabinet).
Ensure a condensation-free environment. Avoid excessive dust,
vibration and shock. The air circulation through the vents must
not be impeded.
Avoid installation in direct vicinity of frequency inverters.
integrates one or two AS-i masters (AC1365/AC1366,
e
onto a 35 mm rail which has an electrically safe gro-
e
and PC: 20 m
e
power supply
e
and DP master: depending on
e
power supply
e
9