Advertisement
Available languages
Available languages
Switching off
To switch off the appliance disconnect the appliance
from the power supply.
If the appliance is out of use for long periods:
Remove the appliance content.
Defrost (model dependent) and clean the appli-
ance thoroughly (see
nance"
).
Leave open the appliance door to avoid formation
of mold and unpleased odor.
Tips for Energy saving
Disconnect the appliance from the power supply if
it isn't in use.
Do not install the appliance near stoves, heaters
or other heat sources. In case of higher ambient
temperatures, the appliance will run more fre-
quently and longer.
Ensure enough ventilation at the bottom and rear
side. Never block ventilation openings.
Place all shelves, racks or drawers (depending on
the model) in their original position.
Adjust the temperature not colder than necessary.
Open the unit door only as necessary.
Defrost the unit regularly (model dependent).
Switch on the lighting only if necessary.
The seal of the appliance door must be complete-
ly intact, so that the door closes properly.
Cleaning and Maintenance
WARNING:
Always disconnect the appliance from the power
supply before cleaning and user maintenance.
Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage
the plastic parts.
The unit must be dry before restarting operation.
"Cleaning and Mainte-
CAUTION:
Do not use a wire brush or other sharp, abrasive
items.
Do not use any acidic or abrasive detergents.
Do not damage the refrigerant circuit.
Cleaning the appliance including interior
Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent; or with a clean,
damp microfiber cloth without cleaning agent.
Remove for that the appliance content and stor-
age at a cool location.
After everything was thoroughly dried, you can
restart the operation.
Dust and anything else that blocks the exhaust air
openings will reduce the cooling capacity of the
unit. If necessary, suck off the exhaust air open-
ing.
Defrosting
CAUTION:
Never use metal objects (e.g. knives) for removing
ice from the vaporizer. The vaporizer could be dam-
aged.
The appliance has an automatic defrosting. During
the defrosting process, the water drops flow through
a drainage channel into a catch tray on the back of
the appliance, from which it then evaporates.
Changing the bulb
CAUTION:
Do NOT remove the cover of the interior light.
The LED light may be replaced / repaired in case of
failure / defect only by an authorized specialist.
37
Advertisement
