Advertisement
Available languages
Available languages
Electrical connection
WARNING:
The installation to the mains supply must conform
to the local standards and regulations.
Improper connection may cause to an electric
shock!
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
Connect the mains cable to a properly installed
and earthed wall outlet.
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Startup / Operation
Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for approx. four hours before connecting to
the power supply. Nonobservance could lead to mal-
function of the cooling system and causes an appli-
ance breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
"Cleaning and Maintenance"
the chapter
Starting the appliance
Connect the appliance to the power supply.
Set the desired indoor temperature. Read the
following sections.
Operation overview
1
2
3
4
5
Press the button (1) to switch the interior lighting
off and on again.
The indoor lighting will turn off automatically after
about 10 minutes, saving energy.
By pressing the button (2), you can change the
temperature display to Fahrenheit or Celsius.
Use the buttons (4) and (5) to set the interior tem-
perature. The display (3) shows the selection.
A few seconds after the last button press, the
temperature display will automatically change to
the actual temperature value currently in the ap-
pliance.
The next time the button is pressed, the display
will first show the last set temperature value.
Settings
The temperature value is adjustable between:
+11°C to +18°C (+52°F to +65°F)
The reachable value cannot be higher than the am-
bient temperature at the place of installation.
During initial startup, longer standstill of the device or
temperature adjustment, there may be a deviation of
.
a few degrees between the temperature you have
selected and the temperature shown on the display.
It takes some time until the desired temperature has
been set.
35
Switch interior lighting on and off
Switch display between °C and °F
Display
Increase temperature stepwise by 1°C (1°F)
Decrease temperature stepwise by 1°C (1°F)
Advertisement
