Power-On And Standby; Power-On - Boss GX-700 Owner's Manual

OUTPUT TYPE : (P.11)
POWER AMP(COMBO)
POWER AMP(STACK)
L(MONO)
MAIN IN
or
EAEE ары RETURN
Power Amplifier
3
Guitar Amplifier Guitar Amplifier
2
OO} OO
Speaker System
| Ози"
сзсзсосзсосз сзсз с
о сзосзсосососососоз oOo е су
EV-5 (Roland)
FV-300L etc.
* To prevent the inadvertent disruption of power to your unit
(should the plug be pulled out accidentally), and to avoid
applying undue stress to the AC adaptor jack, anchor the power
cord using the cord hook, as shown in the illustration.
* If connecting a footswitch (FS-5U; optional) to the CONTROL 1/
2 jack, set the polarity switch as shown below.
Polarity Switch
Power-on and Standby
In order to take full advantage of the GX-700's
performance, be sure to make the following
settings.
Power-on
Once the connections have been completed (p. 9 – 10), turn
on power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
GX-700
Y
External Effects Device
Y
Guitar Amplifier (Power Amplifier)
The following display will appear, and after several seconds,
the GX-700 will be ready for normal playing. This display is
referred to as the "Play page."
5 „з
1 Qu Y Й Й
[| ЕМЕН]
Sound
ah,
T
• Turn up the amp volume only after all devices have been powered
on.
* When the power is turned on, the last-selected Patch number will
be selected,
* This unit is equipped with a protection circuit. A brief interval (a
few seconds) after power up is required before the unit will
operate normally.
* Depending on the location where the GX-700 is placed, the
display may be difficult to read. In this case, adjust the display
contrast (p. 30).