Table of Contents
Advertisement
2 Once again, press the effect select button that corresponds
to the effect you wish to switch. The effect will be turned on
or off.
You can also switch the effect on/off by rotating/pressing
the VALUE knob.
While you are making effect sound settings, the effect
name will be displayed in uppercase characters for an
effect which is turned on, and in lowercase characters for
an effect which is turned off.
3 Repeat steps 1 – 2 to turn each effect on/off.
4 When you finish making settings:
-
If you wish to continue setting other items, make the
desired settings.
~
Ifyou wish to save the settings, use the Write operation
(p.27).
20
Setting the Effect Unit Connection Order
You can freely set the order in which the effects are con-
nected.
(Procedure)
6
4
3
$
TS
EE
T
У
EFFECT SELECT
то
=
== >
1 Press [LEVEL/CHAIN].
2 Use PARAMETER [4][] to access the following param-
eter in the display (CHAIN).
CLENCH]
_ CHAIN
tCS+wah-DS+prets
* Effects which are switched off will be shown in lowercase
letters.
3 Use the VALUE knob to move the cursor (X) to the position
where you wish to insert an effects processor.
4 Using the effect select buttons, select the effect you want.
The selected effects processor will be inserted at the
cursor's position.
5 Repeat steps 3 – 4 to place the effects in the desired order.
6 Press [PLAY] to complete the settings for the connection
order you have produced.
You are returned to the Play page. The display will
indicate that editing is in progress, as shown below.
Editing
=
Eug Пл-г Йй Sound
[NOTE]
While making settings for the connection order you
can also switch effects on/off if you want. The two
effects processors that appear immediately to left and
right of the cursor (#) can be switched off or on by
pressing their respective effect select button.
7 When you finish making settings:
—
If you wish to continue setting other items, make the
desired settings.
~
Ifyou wish to save the settings, use the Write operation
(р.27).
Advertisement
Table of Contents
