Alpine TDM-7548R Manual page 47

e. Replacement of the lever lock/lever mode
switch/roller mode
(1) After removing the rack mode, remove the lever
lock and fever mode switch. (Refer to Figure 8)
(2) Pull it up from the stud and remove the two roller
mode @), @ as shown in Figure 8.
(3) Apply the molykote G paste to the section D-1,
the grease (PG-671) to the section D-2 and mount
the roller mode/lever mode switch/lever lock
following the removal steps in the reverse order.
NOTE : @ Check to see the roller mode is
inserted without fail.
e. UK-AyYI/UN-E-— KAZ VY FS
O-F-E- KFORRAER
(FvF7E-FEALERB LN-Oy7,
LN-E-FAC YF OMICS EREET,
(HisH Fe)
(2) 4NA-F-E-FOOEARyREYW
FeREET, (MSShe)
(3) D-1MBHICEYA-—bGXR-Ak, D-2B9
ICFUR (PG-671) €BAL. RUYALA
NOHOFIBCRWUHIET.
ZEB] © O-F-E-KOMABNPEUYTE,
Head
Chassis
Figure 9
P.C.Board
f. Replacement of gears
f-1 Replacement of the RF gear
(1) Remove M1.2 lock washer @, pull it up from the
stud and remove the gear as shown in Figure 8.
(2) Mount it, following the removal steps in the
reverse order.
ft RFX VP ORBAR
(1) By 7Dyv+e—@® (M12) EAL, ARYA
KSHYRAREFPVTEHLET. (MBER)
(2) MUHA LAOPOFIBCRUEIET.
f-2 Replacement of the take-up gear
(1) Remove M1.2 lock washer@, pull it up from the
stud and remove the gear as shown in Figure 8.
(2) Mount it, following the removal steps in the
reverse order.
NOTES on f-1 and f-2 :
@ Do not reuse the used lock washer
for remounting.
@ Take care to avoid damage by
piercing and tearing.
£2 FI APY SEVP ORBAR
(1) fHONOy 777 v~—@® (M1.2) EAL,
ARyY~hKKOREREL VT ENRLEF, (MSEhR)
(2) RUA LADBOFIRGCRUHWVET,
[f1, [20 3]
O-BeRveav77vyv+-is
AATEC ISEAL GUC FAL,
@Qav7I7yy7—RY tt lees, ORS.
HL NOGVRCFBTSZIL,
® Main motor
Chassis
Control P.C.Board
Figure 10
-17-
| GR-S
SERIES
E
F ;
3
;
|
i
q