Table of Contents
Advertisement
GR-S
SERIES
Disassembly, Assembly and Replacement of Functional Parts
HERE BB ih 5) RE FAI RURRAE
1. Disassembly and Assembly of Bottom Cover
(1) Turn the mechanism around as shown in Figure 1.
(2) Remove three screws () as shown in Figure 1.
(3) Lift the bottom cover slowly from the position A-1, pull the hooks out of the holes in the chassis, and remove
the bottom cover as shown in Figure 1.
(4) Set the mechanism to pack down status and place the mode lever to the position shown in Figure 2-1.
(5) Press the metal switch lever in direction shown by the arrow (refer to Figure 2-2), insert the pinion sub motor
shaft to the pinion sub motor hook hole, and insert the chassis engagement claws into the chassis engagement
holes. (Check to see the sub motor wire is placed in the norma! guide position of B section.)
(6) Rotate the pinion sub motor counterclockwise after insertion of the bottom cover, and check to see the end
place of A section in Figure 2 is closely touched. (refer to Figure 3)
(7) Fix the screws that have been removed.
NOTE : @ When fixing the bottom cover, be careful to avoid
damage by the belt.
@ Fasten the three screws with a fastening torque of 6 kg.cm.
1.
KERLAN-ODBABRVGEWAR
(1) XHAeBRBEICLET,
(M1)
(2) 83EDRVOEHALET.
(Mish)
(38) A-1BPSOKRKLAN-EMDCUEBOL,
DURILORSMEAL,
DRUET.
(His)
(4) AREA(S,
A HENNY TDOWNKABIC LT.
E-KUN-OMBEM2-10%RICSHtEet,
(5)
XRWSWUN—€EMAM
(M2-2688)
(CHL. SUBMOTORE
SRM ESUB MOTORMRANICHA L.
De-VReY
A EV ye - LV RERICHAL ET.
KE LAN-(RRBET.
(LOHR,
YAE-S2-TIV-PBMEMAT
FMBCHScCL)
(6)
RKAAN—(RRBESUBMOTOREAMYVICEL,
M2ARmMHOY
SD + -LeReLAECECeBLET.
(B38 Ra)
(7) PRRBRICH
LEA VEIDOET.
(ERM)
© BIR,
NIU KICBEAU CORICERLTF
SU,
®@ 3K DRVISCKGOMOD hILT CHO HI
TFA
'
Bottom Cover
Figuer 1
=4o=
Advertisement
Table of Contents
