External Monitor - Toshiba Qosmio G40-MM1 User Manual

Qosmio G40
Disconnecting the USB floppy disk drive
When you have finished using the USB floppy disk drive, you can follow the
procedures below in order to disconnect it:
1. Wait for the Disk-In-Use Indicator light to go out to make sure all floppy
disk activity has stopped.
If you disconnect the floppy disk drive or turn off the power while the
computer is accessing the drive you may lose data or damage the floppy
disk or the drive.
2. Click the Safely Remove Hardware icon on the Task Bar.
3. Click the USB floppy disk drive device that you want to remove.
4. Carefully pull the floppy disk drive's USB connector out from within the
computer's USB port.

External monitor

An external analog monitor can be connected to the computer's external
monitor port, with the computer supporting WUXGA video mode. In order to
connect a monitor, follow the steps as detailed below:
1. Turn the computer's power off.
2. Connect the monitor cable to the external monitor port and tighten the
screws on the left and right hand side of the connector as required.
3. Turn the external monitor's power on.
4. Turn the computer's power on.
When you turn on the power, the computer will automatically recognize the
monitor and determine whether it is a color or monochrome device. In the
event that you find that there are issues getting an image displayed on the
correct monitor, you should consider using the FN + F5 hot key to change
the display settings (if you then disconnect the external monitor before you
turn the computer's power off, be sure to press FN + F5 hot key again to
switch to the internal display).
Please refer to Chapter 5,
keys to change the display setting.
9-18
External monitor port
Connecting the monitor cable to the external monitor port
The Keyboard, for further details on using hot
Monitor cable
Screws
User's Manual