Assembly; Contents Of Shipping Carton; Tools Required For Assembly; Contents Of Parts Bag - Craftsman SEARS 536.88502 Owner's Manual

THIS SNOW THROWER IS EQUIPPED WITH "TRAC-PLUS" AND ONLY
MOVES EFFECTIVELY WHEN ENGINE IS RUNNING
If your snow thrower must be moved without the aid o! the engine, it will be easier to pull the snow thrower bank-
ward by the handles, rather than pushing°
On start up, the track drive system may be tight and will loosen up as the snow thrower is used.. After first use,
check the track for tension and adjust if necessary, See the Track Adjustment paragraph in the Service and Adjust-
" ment_ section of this manual.. Check track adjustment and fasteners regularly.
CONTENTS OF SHIPPING CARTON TOOLS REQUIRED FOR ASSEMBLY
1 - Snow thrower completely assembled except for
tlfe_crank assembly, shifter lever knob, the upper
h_ndte, and the chute deflector assembly.
1 - P_rts Bag Containing:
t - C)wner's Manual (Not Shown)
1 - Etectdc Starter Corc195 Fto (Not Shown)
1 - Knife (to cut carton and plastic ties)
2 - 1/2 inch Wrenches (or adjustable wrenches)
2- 9/16 inch Wrenches (or adjustable wrenches)
2 - 3/4 inch Wrenches (or adjustable wrenches)
t - Pair Pliers or Screwdriver (to spread cotter pin)
I
i,=l==,=,rlr=,,= = == = H
1 - 3/8 Inch
Flatwasher
CONTENTS OF PARTS BAG
=l i=l= = ,H,INH imlr=m,riH,
G
1 - 3/8 Inch
Lockwasher
.,H== i
1 - 3/8 Inch
Hex Nut
! l l,l,lal l lJl l,l! i 1)
2 - Spare Shear Bolts
(5/16 - I8 x 2 Inch Hex Head Bolts)
2 - 5/16-t8
Locknuts
)
.I
"1
1 - 318- 16 x 2 Inch
Hex Head Bolt
2 ° Cable Ties
HI=IIIll =l,=ll===,, ,,i,,i,l=lll ii
6
1 -Plastic Knob