Harbor Freight Tools U.S. GENERAL Junior 56515 Owner's Manual & Safety Instructions page 4

6. Insert the threaded end of the Drill (J) through
the slot on the left side of the Pegboard. Secure
in the back of the Pegboard using a Nut (Q).
7. CAUTION! Check that all connections are
secure and all hardware is tight. Hardware used
for assembly should be as tight as possible
without damaging the product or its fasteners.
Page 4
Figure E
For technical questions, please call 1-888-866-5797.
8. An example setup for this product is shown below.
Figure F
56515