Download Print this page

Santec Caprie 9470EZ Installation Instruction page 2

Bidet fitting

Advertisement

HANDLE TRIM INSTALLATION
DO NOT DISASSEMBLE HANDLE ASSEMBLY - DROP-IN VALVES
- Remove the valve body mounting hardware from valve body.
1
Hot valve assembly "Red" to be mounted on left. Cold valve
assembly "Blue" to be mounted on right.
- Apply a ring of silicone caulking around the handle hole on
2
bidet top. DO NOT USE PLUMBERS' PUTTY, WHICH CAN
DAMAGE FINISH.
- Slip valve through appropriate hole on top of bidet. Reinstall
3
valve body mounting hardware, fiber washer and valve body
locknut. Align handles with respect to the bidet, and tighten valve
body locknut until secure.
- Aim outlet hoses towards bidet wye and attach securely to
4
avoid leakage.
POP-UP INSTALLATION
- Remove decorative drain flange and drain plug from pop-up
1
assembly.
2
- Apply a ring of silicone caulking to underside of decorative
drain flange. DO NOT USE PLUMBERS' PUTTY, WHICH CAN
DAMAGE FINISH.
- Insert threaded end of the assembly up from below bidet.
3
Completely thread drain body into decorative drain flange and
align with ball rod hole facing back and tighten lock nut from below.
- Insert drain plug into decorative drain flange with adjustable
4
eye-screw facing back. Attach ball rod washers and ball rod nut
to horizontal ball rod and install into drain body. Do not over tighten,
ball rod must operate freely.
- Drop lift knob flange through appropriate hole in bidet and
5
attach mounting hardware. Insert lift rod and knob through lift
knob flange, lift rod strap and tighten thumbscrew.
- Gently push the horizontal ball rod down to place the drain
6
plug in the up position.
- Slip one leg of ball rod clip off horizontal ball rod and insert lift
7
rod strap, reattach leg of ball rod clip.
8
- Test pop-up for smooth operation and adjust if necessary.
The measurements shown are for reference only. Products and specifications shown are subject to change without notice.
www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681
Lift Knob
Lift Knob Flange
Flange Shank
Rubber Washer
Metal Washer
Lock Nut
Lift Knob
Thumb Screw
Lift Rod Strap
Side Hole
Ball Rod
Ball Rod Clip
Ball Rod Nut
Drain Fla
Gasket
Washer
Lock Nut
Drain Tube
2/5

Advertisement

loading

This manual is also suitable for:

Dome 9470ez