Installation - Zanussi ZF 72 M Instructions For The Use And Care

Table of Contents

Advertisement

Installation
Please note
If you are discarding an old refrigerator
that has a lock on the door, please ensure
that the lock is made unusable to avoid
accidents to young children.
Electricity Supply
The appliance is for operation on a
220/240V 50Hz supply, so be sure that
your electricity supply voltage is within
this range which is marked on the
nameplate located inside the cabinet.
Earthing
WARNING
THIS APPLIANCE MUST BE
EARTHED. The manufacturer declines
any liability should this safety measure
not be observed.
If the plug that is fitted to your
appliance is not suitable for your socket
outlet, it must be cut off and the
appropriate plug fitted.
The cut off plug should be disposed of to
prevent the hazard of electric shocks in
case it should be plugged into a 18 Amp
socket in another part of your home.
Electrical Connection
IMPORTANT
The wires in this mains lead are coloured
in accordance with the following code:
GREEN AND YELLOW - EARTH
BLUE - NEUTRAL
BROWN - LIVE
If you fit your own plug, the colours of
the wires in the mains lead of your
appliance may not correspond with the
markings identifying the terminals in
your plug, this is what you have to do:
Connect the green and yellow (earth)
wire to the terminal in the plug which is
marked with the letter «E» or the earth
symbol + or coloured green, or green
and yellow.
Connect the blue (neutral) wire to the
terminal in the plug which is marked
with the letter «N» or coloured black.
Connect the brown (live) wire to the
terminal which is marked with the letter
«L» or coloured red.
The plug moulded on to the cord
incorporates a fuse. For replacement, use
a 13 Amp BS 1862 fuse.
Only ASTA approved fuses should be used.
The fuse cover/carrier must be replaced
in the event of changing fuse.
The right fuse cover/carrier colour is the
one shown by the coloured insert at the
base of the plug or is the colour of the
inscription at the base of the plug.
The plug must not be used if the fuse
cover/carrier is lost.
A replacement cover/carrier must be
obtained from Zanussi Service Agents
whose addresses are listed in the attached
«Zanussi Service Agents Nationwide».
THIS APPLIANCE COMPLIES WITH
E.E.C. DIRECTIVE N. 82/499 OF 7.6.82
RELATIVE TO RADIO
INTERFERENCE
SUPPRESSION.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zf 55 m

Table of Contents