Table of Contents
Advertisement
Whenever door reversal has been
carried out, the fast-freezing
compartment door should also be
reversed to allow best access
conditions. For this purpose proceed as
follows:
Using a Phillips (crosshead)
screwdriver, remove door catch support
«A» - Fig. 11; remove the two hinges «B»
- Fig. 11 and the relevant door; fit door
catch support «A» upside-down, on the
opposite side of the inner liner; fit. the
door and its hinges «B» on the opposite
side, taking care to turn them upside-
down.
Check correct operation of the door.
Door panelling directions
To fit the front panel, if so required, go
through the following steps:
Take off the removable section of the
door frame from the opposite side with
respect to the hinges after unscrewing
the securing screws (Fig. 12). Unloose,
without removing them, all securing
screws of the door frame.
Slide in, on the side from which the
removable section of the door frame
was taken off, the covering panel and
push it in all the way.
Fasten again the frame to the door,
including the previously removed
detachable frame section.
Note: The over-all dimensions of the
covering front panel should be
1~2 mm smaller than those of the
door, and the thickness should not
exceed 4 mm.
Advertisement
Table of Contents
