Table of Contents
Advertisement
Important
The middle hinge (which can be
displaced horizontally by about 3 mm)
is designed to allow perfect alignment
of the two doors; this can easily be
attained by going through the following
steps:
— Loosen the two screws fixing the
hinge to the cabinet.
— Slightly adjust the hinge until perfect
alignment of the doors is obtained, then
fix the hinge in its new position.
b. Upper and lower door handles
Remove the handle by unscrewing the
two fastening screws (Fig. 9); refit the
two screws in the same locations; refit
the handle upside-down on the opposite
side of the door by means of the pre-
fitted screws.
C. Adjusting the height of the
appliance (Fig. 10)
If you wish to reduce the height of the
appliance from 2.05 m to 2 m continue as
follows:
1. Lay the appliance down flat on its side.
2. With the aid of a screwdriver remove
the screw "A" fastening the bottom
door hinge.
3. Remove the 15 cm kick plate "B" lay
lifting in out.
4. Release the screws "C" fastening the 5
em removable plinth to the product
and remove it.
5. Fit the 10 cm kick plate taking care to
fill in the unused hinge hole with the
cover "D" removed from the 15 cm
kickplate.
6. Remove the two front feet from the 5
cm plinth and replace them directly
onto the base of the appliance.
19
Advertisement
Table of Contents
