Table of Contents
Advertisement
1159SBD0203A
2-3. PAPER TAKE-UP/TRANSPORT SECTION
(1) Removal of the Paper Take-Up Roll and Separator Roll Assy
Remove two screws and the Upper Right Cover.
Remove two screws and the Middle Right Cover.
Remove one screw and the Right Door.
Pull out the Paper Feed Cabinet.
Swing down the Front Door.
Release and swing up the Upper Half of the copier.
.
Remove three screws and the Rear Cover.
<USA, Canada>
NOMA
wpa
8.
Remove one screw and the Imaging Unit from the copier.
8.
Push the lock laver and remove the JU.
9.
Remove each of the two screws and the Paper Take-Up
Roller.
10. Open the Cord Clamp.
11. Remove one screw and the Multi Bypass Paper Take-Up
Solenoid Assy. (EP1031/EP1031F Only)
1159D039AA
D-10
1158D041AA
NOTE
When reinstalling the Multi Bypass Paper Take-Up Sole-
noid Assy, make sure that the marking-off line is aligned
with the triangle of the hole.
12. Remove one screw and the Gide Plate.
13. Remove the Separator Roller Guide Plate.
14. Remove the Rear Gear.
15. Snap off the one E-ring to remove the front and rear Bush-
ings.
NOTE
When reassembling the bushing, make sure not to mis-
take the front and rear components.
The front is plastic and the rear is metal.
16. Move the Separator Roller to the rear and, as shown in by
the sequence in the illustration to the left, remove it from
the front.
(2) Cleaning of the Paper Take-Up Rolls
1159D044AA
1,
Pull out the Paper Feed Cabinet.
Using a soft cloth dampened with alcohol, wipe clean the
two Paper Take-Up Rolls.
D-11
Advertisement
Table of Contents
