Table of Contents
Advertisement
3.
Snap off the two E-rings to remove the one screw and the
Drive Gear.
:
4.
Remove the front Ds Positioning Collar and replace.
NOTE
When replacing the front Ds Positioning Collar, hold the
shaft behind the Bucket Roller.
11590190AA
Snap off the one E-ring to remove the rear Ds Positioning
Collar and replace.
Damp the developer out of the Daveloping Unit.
Set the Starter Bottle to IU and perform adjustment of
the F8 ATDC Adjustment. (See p.D-46)
AISODIG5AA
D-26
3.
Remove the Starter Bottle and set the Toner Bottle.
NOTE
Shake the Toner Bottle before setting it in place.
|
1.
Remove the two screws, the Receiver Plate and the
Toner Antispill Mylar.
1159D167AD
2.
Using a brush, whisk dust off the Toner Antispill Mylar.
1.
Using a brush, whisk dust off the Toner Scattering Pravon.
tion Mylar.
j.
Remove the Timing Roller.
2.
Using a brush, wihisk dust off the Paper Dust Removal
Cleaner.
1159D170AA
D-27
Advertisement
Table of Contents
