Minolta EP1030 Manual page 126

Adjust Mode
[Service Mode p> Adjust Mode]
Setting (The default Is )
<Full size registration adjustment
Corrects registration between the leading edge of the original and that of the
image in the full size made by varying the Synchronizing Rotter start timing.
0.6mm .... sees 6 +6.0mm
Description (Smalier (Greater
deviation) deviation)
<Entargement registration adjustment>
Corrects registration between the leading edge of the original and that of the
Image in an enlargement made by varying the Synchronizing Roller start
timing. :
-2.0mm .... teas +2.0mm
Description (Smaller (Greater
deviation) deviation)
<Reduction registration adjustment>
Corrects registration between the leading edge of the original and that of the
image in a reduction made by varying the Synchronizing Roller start timing.
2.0mm .... sees -42,0mM
Description (Smaller (Greater
deviation) deviation)
<SDH registration adjustment>
Corrects registration between the leading edge of the original fed via the SDH
and that of the image by varying the SDH Registration Roller start timing.
-10mm .... sees 10mm
Description (Smaller (Greater
deviation) deviation)
S-14
[Service Mode > Adjust Mode]
Setting (The default Is )
<Leading edge erase width adjustment>
Corrects the leading edge erase width by varying the Imag Erae Lamp ON
Adjust Mode |
-11.0mm.... +Omm~—.... =+4.0 mm
(Smaller (Greater
width) width)
Description
<ATDC Sensor adjustment data>
Manually enter the setting value previously recorded when the starter has
been changed or the setting value data automatically set by an F8 operation is
cleared. :
NOTE
For details, see DIS/REASSEMBLY, ADJUSTMENT.
<Max. Exposure Lamp voltage adjustment data>
Manually enter the setting value previously recorded if the max. Exposure
Lamp voltage adjustment data set by an F3 operation Is cleared with Data
Clear of Tech. Rep. Choice.
NOTE
For details, see DIS/REASSEMBLY, ADJUSTMENT.
S-15