HEIDENHAIN TD 110 Operating Instructions Manual page 19

1.3.3 Symbols and fonts used for marking text
In these instructions the following symbols and fonts are
used for marking text:
Format Meaning
... Identifies an action and
the result of this action
...
Example:
Tap OK
The message is closed
... Identifies an item of a list
...
Example:
TTL interface
EnDat interface
...
Identifies menus, displays and buttons
Bold
Example:
Tap Shut down
The operating system shuts down.
Turn the power switch off
HEIDENHAIN | TD 110 | 05/2023
2 Safety
2.1 General safety precautions
General accepted safety precautions, in particular the
applicable precautions relating to the handling of live
electrical equipment, must be followed when operating the
system. Failure to observe these safety precautions may
result in personal injury or damage to the device.
It is understood that safety rules within individual
companies vary. If a conflict exists between the material
contained in these instructions and the rules of a
company using this system, the more stringent rules take
precedence.
2.2 Intended use
The TD 110 series products are high-quality sensors for the
non-contacting inspection of end mills and drills inside a
machine's working space. The products are deployed for
breakage detection.
The products of this series
must only be used in commercial applications and in an
industrial environment
are intended for indoor use in an environment in which
the contamination caused by humidity, dirt, oil and
lubricants complies with the requirements of the speci-
fications
must be attached to a mounting surface to ensure the
proper operation of the product in accordance with its
intended use
19