Table of Contents
Advertisement
Switching off low salt
indicator / water softening
system
If the use of combined detergents with a
s t e m
t e r s o f t e n i n g s y
S w i t c h i n g o f f w a
salt component impairs the low salt
indicator P on the control panel or
the text on the display window at the
top @ (enough salt for x rinse cycles),
the displays can be switched off.
Proceed as described under "Setting
water softening system" and set the
value to 0-8. The water softening system
and salt refill indicator are now switched
off.
,
Rinse aid
As soon as the low rinse-aid indicator
R i n s e a i d
H is lit on the control panel or is
requested on the front display * ):,
rinse-aid should be topped up.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26°
Clarke, 3.7 mmol/l) only. If the water
hardness is over 21° dH, rinse-aid must
be used.
* depending on the features of your
dishwasher
Top up the rinse-aid as follows:
Open dispenser 92; press lug on
1.
the lid (1) and lift (2).
Add rinse-aid up to the max. mark.
2.
Close the lid.
3.
Lid "clicks" into position.
Remove overflowed rinse aid with a
4.
cloth.
This prevents excessive frothing
during the next rinse cycle.
Rinse aid en
17
Advertisement
Table of Contents
