Operation; Know Your Snow Thrower; Before Starting; How To Start Your Snow Thrower - Craftsman 486.24838 Operator's Manual

KNOW YOUR SNOW THROWER
Read this owner's manual and safety rules before operating your snow thrower.
Compare the illustration below with your snow thrower to familiarize yourself with the various controls and their locations.
LIFT HANDLE ..................
UPPER CHUTE _f'_"
LOWERCHUTE _
f
SCRAPER PLATE /j
SPIRAL AUGERS, R.H.& L.H.
_ -- LIFT RELEASE TRIGGER CHUTE TILT HANDLE
3RANK ROD
SKID SHOE
CHUTETILT HANDLE Pivots the Upper Chute up or
down to control the angle and distance of discharge.
CRANK ROD Rotates the Lower and Upper Chutes to
control the direction of discharge.
LiFT HANDLE Used to lift or lower the snow thrower
to transport or operating position.
LIFT RELEASETRIGGER Releases the lock which
holds the snow thrower in the transport position
UPPER AND LOWER DISCHARGE CHUTE Controls
direction and height of snow discharge.
SCRAPER PLATE Replaceable plate that absorbs
wear and impact from contact with ground
SKID SHOE Controls amount of clearance between
the scraper plate and the ground
SPIRAL AUGER, R.H. & L.H. Feed snow to the
impeller fan at the center of the housing
BEFORE STARTING
* Use the end of assembly checklist to verify that all
instructions have been properly completed.
Make sure the skid shoes are adjusted to maintain
adequate ground clearance between the snow
thrower and the type of surface to be cleared. (Refer
to the Service and Adjustments section )
* Make sure the tractor engine has the correct oil
for winter operation (SAE 5W-30). Refer to tractor
owneCs manual
HOWTO STARTYOUR SNOWTHROWER
* The tractor should be sitting with the engine running
at full throttle Move the attachment dutch to the
engaged position, starting the snow thrower before
the tractor clutch is engaged
HOWTO STOP YOUR SNOW THROWER
* To stop the snow thrower, disengage the tractor's
attachment cEutch ]ever for manual clutches or the
clutch switch for electdc clutches Refer to your tractor
owner's manual
HOW TO USE YOUR SNOW THROWER
CAUTION: Never direct discharge
towards bystanders or windows Do not
allow anyone in front of unit.
CONTROLLING SNOW DISCHARGE
To control the direction snow is thrown, the discharge
chute has 180 degrees of rotation Turn the crank rod
clockwise to rotate the chute to the right Turn the
crank md counterclockwise to rotate the chute to the
left.
To control the distance snow is thrown, the upper
section of the discharge chute pivots up and down
Push forward on the chute tilt handle to pivot the
chute down, decreasing the distance snow is thrown.
Pull back on the handle to pivot the chute up,
increasing the distance snow is thrown
27