Playing Tracks In Random Order (Shuffle Play); Playing Tracks In The Desired Order (Program Play) - Sony MHC-450 Operating Instructions Manual

To Do this
Find forward Hold down Pi and
quickly ina release it at the desired
track point.
Go backwards Hold down IKK) and
quickly ina release it at the desired
track point.
Search quickly Press 0 and hold down
without I< or DDI. Press > or
listening OU again at the desired
point.
To check the remaining or total
playing time
Use the TIME button on the player.
To check Press
Remaining TIME once during play.
time in a track = ms
a: aa 436 ae
Remaining TIME twice during play
time inthe CD __ of the tracks left.
Total playing TIME in stop mode.
time =
wud 43 ie
appears for a few seconds
Notes
* You can check the remaining time during
normal, shuffle and programme play.
* The total playing time and number of
tracks also appear in the display when
you press & OPEN/CLOSE to close the
CD tray.
Notes on handling discs
*To keep the disc clean, handle the disc by
its edge. Do not touch the surface.
* Do not stick paper or tape onto the disc.
* Do not expose the CD to direct sunlight or
heat sources such as hot air ducts, nor
leave it in a car parked in direct sunlight
as there can be a considerable rise in
temperature inside the car.
If there is no CD in the player
"no dISC" appears in the display when you
press >.
es
Playing Tracks in
Random Order
(shuffle play)
You can play all the tracks on the CD in
random order. Use the buttons on the unit
to do this operation.
SYSTEM POWER—-ON
2 Press SHUFFLE.
"SHUFFLE" appears in the display.
3 Press >,
"©" appears and then all the tracks
play in random order.
To stop playing
Press @.
To cancel shuffle play
Press CONTINUE.
"SHUFFLE" disappears from the display,
and tracks continue playing in their original
order,
_ Ee eee
Playing Tracks in the
Desired Order
(programme play)
You can programme up to 24 tracks to play
in any order you choose. Use the buttons
on the unit to do this operation.
SYSTEM POWER-+ON
1 Press CD.
2 Press PROGRAM.
"PROGRAM" appears in the display.
3 Press IAC or DD! to choose a track.
The track number and the total playing
time appear in the display. If you want
to choose this track, go to the next step.
If not, press <I or D1 again to choose
another track.
Track number Total playing time
ical
4 Press PROGRAM.
The chosen track number and playing
order light up in the music calendar. If
the track number, the playing order and
the total playing time disappear before
you press PROGRAM, go back to step 3.
Note
If "--.--" appears instead of the total
playing time during programming or
during play, this means the total
programmed time has exceeded 100
minutes.
5 Repeat steps 3 and 4 to programme the
remaining tracks you want to be played
in the desired order.
6 Press > (B on the remote
commander).
All the tracks play in the order you
chose.
To Press
Check the CHECK repeatedly*.
programme
Programme a pause [0** (#1)***
Stop play a
Cancel the CONTINUE****
programme play
Erase a track from _ CLEAR in stop mode.
the end
Erase a specific CHECK repeatedly
track so the number of the
track lights up, and
press CLEAR.
Erase the entire @ once in stop mode.
programme @ twice during play.
* — After the last track appeared, "END"
will appear in the display.
** "P" appears in the display and the total
playing time is reset to 0.
*** Remote commander
**** The programme has been erased and
the play continues in normal play
mode.
continue to next page >
Chapter 2: the CD Player | 7