Table of Contents
Advertisement
ENGLISH
E. VIDEO IN/OUT
- VCR 1 IN/OUT — input and output jacks for connecting
the video output and input of a video recorder
- MONITOR OUT - output jack for connecting to the video
input of a TV set. The TV set must then be swiched to
that input.
F. SUBWOOFER - Output jacks for connecting a separate
3
amplifier.
« Connect SUBWOOFER output jacks to SUBWOOFER
input jacks of separate amplifier or inputs of a powered
SUBWOOFER.
|
G. REAR SPEAKERS
Terminals for connecting a pair of rear speakers,
impedance of 4 © each, to obtain a surround sound
effect.
NOTE : Always connect two speakers to these terminals.
H. CENTER SPEAKER
Terminals for connecting a center speaker, impedance 8
ohms.
i. FRONT SPEAKERS
Terminals for connecting a pair of speakers, impedance
8 ohms (L = left, R = right).
* One of the wires of a loudspeaker cable is marked with
a colour or rib. Connect the marked wire to the red
terminal, the non-marked wire to the black one.
DIGI LINK Il SYSTEM CONTROL
(colored green) — remote-control input/output jacks for
connection to the corresponding DIGI LINK II or Ill jacks
of a Sherwood CD (Compact Disc) or tape
player. Connect this jack to the DIGI LINK II jack of the
external equipment that uses the DIGI LINK II or Il
remote control system.
These jacks have been added to maintain compatibility
with other Sherwood products.
POWER
K. POWER LEAD
Connecting the receiver to the AC power outlet.
L. OUTLETS
- Switched output for connecting AC power plugs from
various units Such as cassette deck, CD player, etc.
(Maximum capacity is 100 W).
Power supplied through this outlet is turned on and off
by the POWER button of the receiver.
CONNECTING HEADPHONES
¢ Connect headphones with a 1/4"
plug to the PHONES jacks.
— Inserting the plug will not
disconnect the loudspeakers.
-— Turn the speakers off by
pressing the SPEAKER switch
once, press again to turn
speakers on. Also ensure
receiver is not in Surround
modes.
SPEAKER POSITIONING
To obtain the best surround sound effect in your home,
place the speakers as shown below.
The left and right speakers should be about 1 m (40") from
the TV set.
The center speaker should be above or below the TV set.
The rear speakers should be placed at normal listening ear
level.
Note : to avoid interference with the TV picture, use only |
magnetically shielded speaker systems.
After making all necessary connections (some may not
apply to your system set-up), your system is ready for use.
In the next chapter, we will describe how to operate your
R-125RDS receiver.
|
Advertisement
Table of Contents
