Table of Contents
Advertisement
DISPLAY BUTTON
Pressing the "DISPLAY" button lets you check several special displays in the viewfinder.
Battery Level and Linear
Time Counter
LINEAR TIME COUNTER
Shows length of tape run in hours, minutes and sec-
onds.
Press "DISPLAY"
button to select the linear
time counter display.
Load a cassette into the camera/recorder and perform
recording or playback; the counter indicates the elapsed
time.
NOTES:
¢ The
linear time counter
does not operate when
nothing is recorded on the tape.
@ Counter changes to 0:00:00 when cassette is ejected.
MEMORY
When the linear time counter with memory indication
appears in the viewfinder, a tape that is being rewound
automatically stops when the counter reads approxi-
mately 0:00:00'.
This is useful if there is a section of
tape you want to review immediately after recording or
if you want to return to the same point several times in
a row.
1. Press "DISPLAY" button until the linear time coun-
ter is displayed.
2. Press "MEMORY" button.
(The indicator ""M" ap-
pears in the viewfinder.)
3. Start playing or recording a tape.
4. At the point you want
playback
to start, press
"RESET/T-160"
button
to reset the counter
to
**0:00:00"'.
5. Continue to play or record.
6. Press "STOP" button.
7. Press '""REW" button.
The tape will be rewound to
the preselected point, at approximately "0:00:00"
indication.
NOTE:
The
tape
will
also
stop
approximately
at
"0:00:00" during fast forward mode.
1st press
2nd press
Battery Level and Time-
Remaining Display
3rd press
Removes
Display
"DISPLAY" Button
"REW" Button
"STOP" Button
"DISPLAY" Button | "MEMORY" Button
"RESET/T-160" Button
E27
Advertisement
Table of Contents
