Cabinet Adjustment - True GDM-49-HC-TSL01 Installation Manual

TRUE
glass door merchandisers
SLIDE DOOR OPERATION (CABINET ADJUSTMENT)
STEP 1 - Before removing slide door do not use the side latch.
Tension on the door cord is needed to execute these operation
instructions. Doors can not be removed unless placed in specific loca-
tions stated in these instructions.
STEP 2
Two Door Units: Slide the front door so it is centered on the
cabinet. The door can not be removed unless it is centered. See
image 1 for door channel openings and image 2 for centering
door.
1
(Two Door Units ONLY)
CENTERED DOOR
2
(Two Door Units ONLY)
Three Door Units: Slide the middle door to the right so it is
centered with the left edge of the right door. See image 3.
3
(Three Door Units ONLY)
11
STEP 3 - After centering the door lift it up and tilt top of door towards
the back of the unit so the rollers are out of the top channel. Swing
the bottom of the door out of the bottom channel. Then remove the
door and set it down. See image 4.
4
(TWO DOOR UNITS SKIP TO STEP 6)
STEP 4 - Slide right door to the left so left edge lines up with the
left edge of TRUE Logo located above the door. See image 5. Then
lift door out of track same way as image 4.
TRUE Logo
(Three Door Units ONLY)
. .
www truemfg com
5