Connecting The Bathroom Speakers - Samsung HG55Q60AAAWXXY Install Manual

Connecting the Bathroom Speakers

You can connect the Bathroom Speakers using the following method.
Connecting through the Variable Output (available without an external amplifier)
TV Rear Panel
• The rear panel may differ depending on the model.
1 Connect the VARIABLE AUDIO OUT port of the TV to the Bathroom Wall Speakers of the hotel.
2 Connect the VOL-CTRL port of the TV to the Volume Control Box Switch port on the Bathroom Wall of the hotel.
– The maximum speaker output is 4W, 8Ω.
– The VARIABLE AUDIO OUT port supports MONO sound out only.
• Installing the Volume Control Box
– If you configure the Volume Control Box as shown in the figure, you can control the volume of the bathroom
speakers.
– The port that connects the Volume Control Box to the TV is a 3.5 mm normal Phone jack.
– Volume Control Box switch is a Tact switch.
• Setting the Sub AMP Mode
– 0: Turns the Sub AMP function off (PWM off).
– 1: Determines the Sub volume according to the TV speaker sound volume. The TV speaker sound and VARIABLE
AUDIO OUT volume are determined according to the Power On Volume Num, the Min Volume, and the Max
Volume values in the Hotel Option menu.
– 2: Determines the volume according to the Volume Control Box setting.
• VOL-CTRL Port Specifications
– Speaker Wire: Use speaker cable no more than 25 m in length.
VOL - DOWN (White 1)
1
2
Speaker +
Speaker -
VOL - UP (Black /Red 2)
GND (Shield Wire 3)
English - 28
Speaker
VOL+
Volume Control Box
VOL-
N/C
Volume Control Box
1
3
2
VOL +
VOL -