Connecting The Bathroom Speakers - Samsung HG22NE690 Series Installation Manual

You can connect the Bathroom Speakers in the following manner.
Available ports may differ depending on the model.
Connecting through the Variable Output (available without an external amplifier)
TV Rear Panel
1. Connect the VARIABLE AUDIO OUT
Speaker +
Speaker -
✎ The VARIABLE AUDIO OUT
✎ Speaker Wire: Use speaker cable no more than 82 feet (25m) in length.
✎ The maximum speaker output is 4W, 8Ω.
2. Connect the VOL-CTRL
VOL - DOWN VOL - UP
(White 1) (Black /Red 2)
y Installing the Volume Control
– If you configure the Volume Control Box as shown in the figure above, you can control the volume of the
bathroom speakers.
– The jack that connects the Volume Control Box to the TV is a 3.5mm normal Phone jack.
– Volume Control Box switch is a Tact switch.
3. Set the Sub AMP Mode
– 0: Deactivates the sub amplifier that outputs the voice signal of
from VARIABLE AUDIO
– 1: Adjusts the voice output of
settings for the Hotel mode menus of Power On Volume Num, Min Volume, and Max Volume apply to the TV,
speakers, and VARIABLE AUDIO
– 2: Determines the volume according to the bathroom control panel setting.

Connecting the Bathroom Speakers

port of the TV to the Bathroom Wall Speakers of the hotel.
N/C
port supports MONO sound out only.
jack of the TV to the Volume Control Box Switch port on the Bathroom Wall of the hotel.
GND
(Shield Wire 3)
OUT.
VARIABLE AUDIO OUT
OUT.
2
1
Volume Control Box
VOL +
1
3
2
VOL -
VARIABLE AUDIO
according to the volume level of the TV speaker. And all
Volume Control Box
VOL+
VOL-
Speaker
OUT. No voice signal is output
English
29