Nitrous Oxide Accessories - Nos 02125NOS Owner's Manual

Table of Contents

Advertisement

Engine detonates heavily
when system is activated.
High rpm misfire when
system is activated.
Surges under
acceleration when
system is activated.

Nitrous Oxide Accessories

NOS systems are calibrated for optimum performance with a bottle pressure of 950 psi. The pressure will change with temperature.
Heater kits are thermostatically controlled to keep the bottle near 85° F to provide correct pressure. Bottle Heater (P/N 14164NOS) is
available for 10 & 15 lb. bottles. Bottle Heater, P/N 14169NOS, is pressure-controlled to keep your bottle at 950 psi.
Insulating the bottle helps maintain pressure by keeping heat in the bottle when it's cold, or heat out when it's hot outside. The blankets
are made of a rugged, easily cleaned Nylon outer shell with insulation. It's also an excellent "dress up" accessory and perfect for
"covering" battle-scarred bottles. Bottle Blanket (P/N 14165NOS) is a 7" diameter blanket for the 10 lb. bottle.
#10 Bottle Heater P/N 14169 NOS
The Nitrous Pressure Gauges, P/N 15910NOS (-4AN lines) or P/N 15912NOS (-6AN lines) [0-1500 PSIG] are designed to provide
accurate (± 2% of full scale) readings of fuel pressure in carbureted applications.
The Fuel Pressure Gauges, P/N 15906NOS [0-120 PSIG] and P/N 15900NOS [0-15 PSIG] are engineered to provide accurate (± 2%
of full scale) readings for high and low fuel pressure applications.
Too much nitrous flow.
Inadequate fuel delivery
due to restricted fuel
filter.
Crimped fuel line.
Weak fuel pump.
Excessive spark plug
gap.
Weak ignition/ignition
component failure.
Inadequate supply of
nitrous.
Nitrous & Fuel Pressure Gauges
Inspect fuel filter.
Inspect fuel line.
Install fuel pressure gauge. Run engine
under load at wide-open throttle, with
system activated.
Inspect spark plugs.
Inspect components (plug wires, coils,
etc.)
Check bottle weight.
#10 Bottle Blanket P/N 14165NOS
Reduce nitrous jetting.
Clean or replace filter.
Replace crimped line.
Repair/replace fuel pump.
Set spark plug gap at
0.030" to 0.035".
Replace worn
components.
Replace with full bottle.
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

13125nos

Table of Contents