Table of Contents
Advertisement
MOBILITY
For tires with special approval:
performing a reset
1.
Apps menu
2.
"Vehicle"
3.
"Vehicle status"
4.
"Tire Pressure Monitor"
5.
Make sure that the tire settings are correct.
Tire settings, refer to page 328.
6.
Turn on drive-ready state and do not drive
off.
7.
Reset tire pressure: "Perform reset".
8.
Drive off.
The wheels are displayed in gray and the fol-
lowing is displayed: "Resetting tire pressure...".
After a travel time of several minutes, the set
tire inflation pressures are accepted as the
predefined tire inflation pressures. The reset is
completed automatically while driving.
After a successfully completed reset, the
wheels on the control display are shown in
green and the following is displayed: "Reset
successful."
You may interrupt this trip at any time. When
you continue driving the reset resumes auto-
matically.
Messages: for tires without special
approval
General information
When a flat tire is indicated, the Dynamic Sta-
bility Control may be turned on.
330
Wheels and tires
Online Edition for Part no. 01405A8A5A2 - VI/23
Safety information
Warning
A damaged regular tire with low or no tire
inflation pressure impacts handling such as
steering and braking response. There is a risk
of accident. Do not continue driving. Repair
the flat tire or replace the wheel.
With recommended tire pressure test
Message
An icon with service information is shown on
the control display and, if necessary, in the My
BMW App.
Icon
Possible cause
Leak detected on the tire.
Measure
Check the tire pressure and correct as needed.
If a tire inflation pressure check is
required
Message
An icon with a Check Control message appears
on the control display.
Icon
Possible cause
Inflation was not carried out accord-
ing to specifications, for instance
when the tire has not been suffi-
ciently inflated or in the case of a nat-
ural steady tire pressure loss.
Measure
Check the tire pressure and correct as needed.
OwnersManuals2.com
Advertisement
Table of Contents
