Table of Contents
Advertisement
Quick Links
INSTALLATION MANUAL
COMPUTER INTERFACE CI-600
To obtain optimum results from this computer interface, please follow instructions in this manual
carefully. We suggest that you keep this manual handy for future reference.
CONTENTS
GENERAL DESCRIPTION...................................................... 1
PART NAMES....................................................................... 1
INSTALLATION..................................................................... 2
Input control connector and DC power supply ........... 3
Speech IN/OUT terminals.......................................... 3
RS-232C connection.................................................. 4
BACK-UP BATTERY.............................................................. 5
INITIAL SET-UP OF CI-600 ................................................... 6
SPECIFICATIONS................................................................. 7
ACCESSORIES..................................................................... 7
Advertisement
Table of Contents
Related Manuals for Toa CI-600
Summary of Contents for Toa CI-600
-
Page 1: Table Of Contents
INSTALLATION MANUAL COMPUTER INTERFACE CI-600 To obtain optimum results from this computer interface, please follow instructions in this manual carefully. We suggest that you keep this manual handy for future reference. CONTENTS GENERAL DESCRIPTION... 1 PART NAMES... 1 INSTALLATION... 2 CONNECTION Input control connector and DC power supply ... -
Page 2: General Description
GENERAL DESCRIPTION The Toa CI-600 Computer Interface is used in conjunction with the SI-62 Speech Interface and the EX-610, EX-620 or EX-630 exchange. Connected to a personal computer or data terminal, the CI-600 permits system programming, personal information display, release of fixed messages, etc. -
Page 3: Installation
INSTALLATION 1.Rack mounting (exchange is mounted in an equipment rack.) Attach the supplied brackets to the CI-600 to mount in a rack. See the figure. Fiber washer M3 washer M5 tapping screw M3 binding head screw 2. Desk-top applications Attach the supplied rubber foot to the position indicated with a small hole (4 holes 2.4mm in diameter) in the bottom plate. -
Page 4: Connection
CI-600 e x c h a n g e . When placing the CI-600 on the exchange, use the YR-802 cable ( 4 0 c m ) . Use the YR-803 or YR-807 cable to connect the CI-600 to other equipment. -
Page 5: Rs-232C Connection
3. RS-232C connector Connection between CI-600 and DEC VT-100 terminal Connect the DEC terminal and CI-600 using the appropriate cable for distance between the two. The type of connector is D-sub 25 pins (male) and D-sub 25 pin (female). [Connection diagram]... -
Page 6: Back-Up Battery
Connection between Cl-600s (tie-line connection) In a tie-line system, connect one Cl-600's RS-232C connector No.2 to the same connector of another CI-600 only when initial set-up is performed. (Refer to the operating instructions.) [Connection diagram] BACK-UP BATTERY The Ni-Cd battery (GB50-3FA1) maintains the Cl-600's stored data during power failure. -
Page 7: Initial Set-Up Of Ci-600
INITIAL CHECK-UP OF CI-600 Connect IN/OUT lines, power lines and speech IN/OUT lines to both the exchange and CI-600. Using the RS-232C cable, connect Cl-600's RS-232C connector No. 1 to personal computer or data terminal. Set both MODE SELECT and BAUD RATE DP switches. -
Page 8: Specifications
SPECIFICATIONS Operating power voltage Current consumption Terminal capacity IN-OUT connector/terminal Standard Message capacity Recording & reproduction Ambient temperature Dimensions Weight Specifications are subject to change without notice. ACCESSORIES Rack mounting bracket Rack mounting screw (M5×12) Fiber washer Binding head screw (M3×6) Washer (M3) Rubber foot Floppy disk...
Need help?
Do you have a question about the CI-600 and is the answer not in the manual?
Questions and answers