The Green Light Is Flashing But Cannot Access The Captive Portal; Telemetry Is Only Received When The Pill Is Powered By Usb-C; Validation Code Is Not Appearing On The Pill Captive Portal; Error Message Displayed On Phone Or Tablet When Connecting To The Pill Captive Portal - KegLand RAPT Pill KL20596 Instruction Manual

RAPT Pill Hydrometer Instruction Manual

The green light is flashing but cannot access the Captive Portal

Ensure that you have connected to the Pill's wifi network on your phone or tablet (in the form
KegLand Pill XXX)
If the Pill Network does not show up in your list of WiFi networks it may be necessary to 'reboot' the
Pill. To do this, unplug the Pill from USB-C and carefully remove the battery. Wait for 30 seconds
then reinsert the battery (being careful to observe correct polarity) and plug the Pill into USB-C. The
Pill WiFi Network should now appear in your list of networks.

Telemetry is only received when the Pill is powered by USB-C

Ensure you have updated to the current firmware. Check that the battery is making good connection
with the battery terminals of the Pill's board. It may be necessary to gently bend these out in order
to ensure the battery is making good contact in order to power the Pill when it is not connected to
USB-C

Validation code is not appearing on the Pill Captive Portal

If the space for the Validation code on the Pill Captive Portal is blank then make sure that your RAPT
Pill is connected to your home Wi-Fi network (See Determine whether your RAPT Pill is connected to
Wi-Fi below). If it is connected to WiFI but not displaying a validation code then perform a Check for
new firmware to update to the current firmware.

Error message displayed on phone or tablet when connecting to the Pill Captive Portal

You may occasionally see an error message on your phone or tablet when connecting to the Pill
Captive Portal. This will display a message that the 'network is not connected to the internet' and
your device may not allow a connection to the Pill.
To clear this message and allow connection select the Pill WiFi Network on your phone or tablet and
select the "Forget This Network" option. Unplug the Pill and plug it back in after 60 seconds. You
may now connect to the Pill Captive Portal. You will need to re-enter the Pill password (kegland1)
www.KegLand.com.au Last Updated 6/12/2023 3:24 PM
Page 20 of 21