Using Rapt Pill With Kl31936 Complete Wireless Charging Kit; Troubleshooting Wireless Charging; Red Led Does Not Illuminate; Green Led Does Not Start Flashing - KegLand RAPT Pill KL20596 Instruction Manual

RAPT Pill Hydrometer Instruction Manual
Note: Bluetooth requires a compatible RAPT device such as a Fermentation Chamber or
Temperature Controller. Bluetooth will not broadcast unless the RAPT Pill is first registered to the
RAPT Portal using WiFi.
When a Pill has been bonded with a compatible RAPT device the RAPT device can then be set to
use the Pill as the Temperature Sensor. Doing this allows temperature control using real time
telemetry from the bonded Pill. This will also display up to date temperature and gravity data on
the RAPT device.

Using RAPT Pill with KL31936 Complete Wireless Charging Kit

Use of the KL31936 Complete Wireless Charging Kit with the RAPT
ease of use and minimising the need to calibrate the Pill after charging, updating firmware etc.
Once the Complete Wireless Charging Kit or the
Weights only) has been correctly installed (please refer to
the Pill can be wirelessly charged.
Wireless charging also allows for updating the firmware and accessing the Pill Captive Portal without
needing to open the Pill housing to plug the Pill into USB-C.
To charge the Pill simply place it on the wireless charging base, ensuring that the coils are centred
over the indicated charging spot on the base. When the Pill is placed on the base the red LED will
illuminate to indicate that the Pill is charging. The green LED will start flashing indicating that the Pill
is broadcasting a signal so that you can connect to the RAPT Pill XXXX WiFi to open the Captive
Portal.
RAPT Pills will periodically check for OTA (Over The Air) firmware updates when charging
commences, so this is typically all that is required to ensure that your firmware stays up to date.

Troubleshooting Wireless Charging

Red LED does not illuminate

•
The Pill may not be centred on the battery icon on the wireless base station
•
The base station may not be plugged in to USB-C or the USB-C may not be providing
sufficient power
•
The Wireless Charging Kit may not be installed properly
•
The 18650 Li-ion battery may be faulty

Green LED does not start flashing

•
The battery may not be sufficiently charged to power the Pill board. Wait at least 6 hours for
sufficient charge, then remove the Pill from the wireless station and replace on the station
after 60 seconds
•
The Pill may require a reboot. Remove the Pill from the wireless station. Open the housing
and unplug the wireless kit from the USB-C port on the Pill board. Wait for at least 30
seconds, then plug the wireless charging kit back in and replace the Pill on the charging
station
Page 16 of 21
KL32452
www.KegLand.com.au
Pill is very useful for increasing
Barebones Wireless Charging Kit (Coil and
this video for an installation guide) then
Last Updated 6/12/2023 3:24 PM