Table of Contents
Advertisement
Extending the Life of Your Spreader through Proper Maintenance
We at Chandler Equipment Co. are pleased that you have selected our equipment. We feel, as
we are sure you do, with the high cost of fertilizers, repairs, and parts, that proper maintenance
of equipment should be a high priority.
This unit is a major investment and must be maintained properly for years of excellent service.
Listed below are some of the areas that require constant attention:
1) A Chandler Fertilizer Spreader comes standard with a STAINLESS STEEL MESH
TYPE CHAIN. Due to the construction of this chain it will stretch approximately 16
inches in the first few weeks of service. Adjustment can be made on your front roller to
take care of the first few inches of stretch. Once the adjustment is used, back off on the
adjustment rods and remove as much chain as possible. Removal of chain will probably
be required a couple of times. After the initial stretch has been taken out, only occasional
adjustment of the chain will be necessary. Adjust chain tension rods the same on both
sides. When properly adjusted, the chain should just clear the cross members of spreader
frame. Be sure to keep build up cleaned out from under the mesh chain.
2) Be sure to check HYDRAULIC OIL level daily. Located on the front of the oil tank is
an oil temperature/ oil level gauge. The oil level should be maintained within 1 inch of
the black line at the top of the gauge. Never fill the tank past the black line or allow oil
level to get below the red line as this could damage the hydraulic system of your
spreader.
3) Grease bearings and U-joints daily when unit is in use.
4) Maintain proper lubricant level in gear case. At first sign of an oil seal leak, replace
immediately.
5) Spreader body should be washed down occasionally and especially when not to be used
for an extended period of time. Wash with 4 parts fuel oil and 1 part 10 W motor oil.
6) Be sure to run the material divider throughout its entire adjustment range daily and keep
adjustment rod greased. Doing so will maintain proper adjustment function.
7) Spinner Assembly Maintenance
A) Spinner Blades
• The spinner blades are a wearable item and must be checked regularly for
B) Spinner Disc
• Check spinner disc daily for wear. If spinner disc are worn or do not spin
C) Spinner Bearings
• Check spinner bearings daily for wear and movement. Replace spinner
wear. If spinner blades are worn, bent or have holes, replace immediately for
proper spread pattern.
true, replace immediately for proper spread pattern.
bearing immediately if there is any movement in bearing. This can cause
serious damage to spinner disc and motors. DO NOT OVER GREASE
7 - 1
Advertisement
Table of Contents
