Table of Contents
Advertisement
9) Attach the driveline to the tractor PTO and implement PIC. Make sure each
end is firmly attached to its respective shaft.
10)
Make sure driveline does not bottom out when the implement is fully
raised, and that at least 1/3 of the tube is engaged when the implement is at its
lowest height.
LUBRICATION
• Always wear adequate safety equipment when performing any maintenance
• LUBRICATION OF THE UNIVERISAL JOINT
o Rotate the shielding until opening the access hole. Lubricate, and close
the hole by rotating the shielding.
• LUBRICATION OF THE 650 CV JOINT
o Rotate the shell to expose the grease fitting and inject grease.
• LUBRICATION OF THE TELESCOPING TUBES
o If grease fittings are not provided, separate the two halves of the
driveline and manually lubricate the telescoping tubes.
• Check that all components are in good condition and properly lubricated
before using the driveline. Clean and re-lubricate the driveline before storage
at the end of the season.
o Lubrication the 650 type 70° CV joint every 8 hours.
o Lubricate all other components every 50 hours.
o Pump grease into the crosses until it purges from the bearing caps.
o Inject grease gradually and avoid pumping the grease gun violently with
resulting high delivery pressure.
o Use NLGI grade 2 grease.
o Before storage at the end of the season remove any grease that has
accumulated inside the CV joint shield.
• Replace worn or damaged parts with genuine Bondioli & Pavesi spare parts.
o Do not modify or tamper with any part of the driveline.
o For any operations not explained in this manual, consult your implement
dealer or manufacturer, or your local Bondioli & Pavesi representative.
P - 2
Advertisement
Table of Contents
