Table of Contents
Advertisement
BRUSH
See Figure 24.
_k
WARNING: To prevent accidental starting that
could cause possible serious personal injury,
turn off the saw, lock knob in the off position, and
unplug the saw before working on the band saw,
There is a brush located inside the saw's cover, next
to the lower right wheel. The brush helps protect the
tire and wheel by brushing off saw dust. As the brush
becomes worn, it will need to be adjusted or replaced.
•
Loosen the screw to slide the brush and holder
toward the wheel. The brush should just touch
the wheel.
•
Carefully pull the brush straight off of the brush
holder to replace the brush. Push the new brush
on the holder until you hear it snap in place.
•
Remove the brush holder screw to replace both
brush and holder.
BRUSH
BRUSHHOLDER
BRUSHHOLDER
SCREW
Fig. 24
BLADE
GUIDES
See Figures 18 and 19 on page 17.
•
The blade guides may become rounded and
worn during use. Remove the blade guides and
file or grind flat.
•
Replace the guides when filing or grinding has
worn down guides and they can no longer be
properly secured in place.
MOTOR/ELECTRICAL
•
Frequently vacuum or blow out any sawdust from
the motor.
_1,
WARNING:
If the power cord is worn, cut, or
damaged in any way, have it replaced immedi-
ately by a qualified service technician at a Sears
store. Failure to do so could result in serious
personal injury.
,_,
WARNING:
To avoid fire or electrocution,
reassemble electric parts with only identical
Craftsman replacement parts. Reassemble
exactly as originally assembled.
MOTOR
BRUSHES
See Figure 24.
Your saw has externally accessible brush assemblies
that should be periodically checked for wear. When
one of the two brushes becomes worn, replace both
brushes.
•
Unplug your saw.
,_
WARNING:
Failure to unplug your saw could
result in accidental starting causing serious
injury.
•
Remove brush cap with a flat blade screwdriver.
Brush assembly is spring loaded and will push
against the cap as it releases.
•
Remove brush assembly.
•
Check for wear. If one brush is worn down
shorter than 1/4 in., replace both brushes. Do
not replace one side without replacing the other.
•
Reassemble using new brush assemblies. Make
sure curvature of brush matches curvature of
motor and that brush moves freely in brush tube.
•
Make sure brush cap is oriented correctly
(straight) and replace.
•
Tighten brush cap securely. Do not overtighten.
•
Repeat for other brush.
Fig. 24
22
Hide quick links:
Advertisement
Table of Contents
