Table of Contents
Advertisement
SPECIALSETTINGS
» LNB Selection«: If more than one
satellites are used in the current SCR
system, select »1/2« to»2/2« for the
satellite corresponding to the relevant
positions using »
– » LNB Power«: Set the LNB power to
»Off« or set it to »13/18V« or »14/19V«
depending on the LNB type by using »
>
or »
«.
Notes:
Use installation equipment supported / sug-
7
gested by your SCR Switch.
Other users / receivers connected to the
7
system may be affected if the specified user
band number and frequency is changed dur-
ing installation.
User band and user band frequency is speci-
7
fied on the SCR switch used; and each user
/ receiver must select a specified user band
and user band frequency.
With SCR satellite system, auto search by
7
several users / receivers at the same time
may cause problems.
– » DISEqC Mode«: Based on the number of
current satellite system, select the option
»Off« »DiSEqC 1.0« or »DiSEqC 1.1« with
<
>
»
« or »
«.
» Off«: For satellite systems with single
antenna.
» D iSEqC 1.0« switch allows for receiv-
ing from maximum four satellites at
the same time.
F rom »LNB selection« use »
to make the »1/4«, »2/4«, »3/4« or
»4/4« selection for the satellite that
corresponds to relevant DiSEqC posi-
tions.
» D iSEqC 1.1« switch allows for receiv-
ing from maximum sixteen satellites
at the same time.
- ---------------------------------------------------------------------------------------
<
>
« or »
«.
<
«
<
>
« or »
F rom »LNB selection« use »
>
»
« to make the selections between
»1/16« and »16/16« for the satellite
that corresponds to relevant DiSEqC
positions.
8 Press »EXIT« to end the setting.
Motorantennasetup
(DiSEqC1.2)
Your television supports DiSEqC 1.2 motorized
satellite systems. This feature allows to control
the satellite through your television.
1 Open the menu with »MENU«.
2 Activate the menu item »Settings« with
»OK«.
3 Select the menu item »Source Setup« with
>
<
»
« or »
« and press »OK« to confirm.
4 Select the line »Manual Channel Search«
with »
« or »
V
firm.
5 Select the option »Satellite« with »
and press »OK« to confirm.
6 Activate the option »Antenna Settings« with
»
« (blue).
– The »Antenna Settings« menu is dis-
played.
7 Select the line »DiSEqC Mode« with »
»
« and select »DiSEqC1.2« with »
Λ
>
»
«.
– T he line »DiSEqC 1.2 SETTINGS« is ac-
tive.
Note:
Additional operations are explained in the
7
following sections.
Settings regarding DiSEqC 1.2 are ex-
7
plained below. Contact an expert or your
dealer for DiSEqC 1.2 antenna systems.
<
« or
« and press »OK« to con-
Λ
<
ENGLISH
>
« or »
«
« or
V
<
« or
83
Advertisement
Table of Contents
