Transportation & Placement; Before Transporting Your Auger - HARVEST H13102 Operator's Manual

3. Transportation and Placement

3.1 Before Transporting your Auger

Remove wheel chocks, so wheels are free to move.
DANGER:
If auger wheels are stuck in grain, mud, dirt, or snow. remove the
restraining substance from around the wheels before transport. Failure to
do this could cause damage to the auger, and serious injury or death.
All Harvest International augers have minimum clearance positions when in
transport mode. Place auger in full down position.
DANGER:
Electrocution Hazard! Make sure that all unauthorized personnel are clear
from the transport zone. This auger is not insulated. Be alert to overhead
obstructions and electrical wires. Electrocution can occur without direct
contact. Do not raise or lower auger until hazardous area is cleared. Failure
to maintain proper clearance can result in serious injury or death.
Put hitch pin in place, and ensure that the safety chain is properly attached. Use
a type of hitch pin that will not allow the auger to detach itself from the tractor.
If you have questions about appropriate hitch pins, contact your tractor
manufacturer.
Put PTO driveline and swing hopper into transport position and lock into place.
If swing hopper is not in transport position, the hopper will be damaged during
transport.
Put jack in raised position and lock into place. Use caution when working with
hitch jack.
If you have a light package for your auger, make sure the connections are
fastened securely and not dragging on the ground.
_
7