Attachment (See Illustrations) - EuroLite LCD-MOUNT LCH-37M User Manual

Procedure:
The device should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the device. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and or
damage to property.
Caution: Devices in hanging installations may cause severe injuries when crashing down! If you have
doubts concerning the safety of a possible installation, do NOT install the device!
Before taking into operation for the first time, the installation has to be approved by an expert!

Attachment (see illustrations)

Before attaching the device, make sure that the installation area can hold a minimum point load of 5 times
the device's weight.
The wall-mounting must be installed out of the reach of people.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
The wall-mounting must always be installed via a minimum of 4 fixation holes with a minimum distance of 15
cm. Do only use appropriate screws and make sure that the screws are properly connected with the ground.
Procedure:
Step 1: On the wall-mounting, there are holes for the installation.
Step 2: Hold the wall-mounting onto the location where it is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the wall-mounting in the desired position and tighten the screws.
Step 6: Install the tv on the wall-mounting.
Attaching the screen brackets
Always refer to the TV user manual before attaching the screen brackets!
The number of fasteners used will vary, depending upon the type of screen.
Multi-washers and spacers may not be used, depending upon the type of screen.
Please note that some tvs must not be inclined over a certain degree due to thermal reasons.
Procedure:
Place the two adjustable screen brackets against the back of the screen. The hook-shaped part should point
upwards and the fixing knobs should face away from the screen.
Various screws and spacers have been supplied for the attachment of the mounts to different screen
models.
Check which mounting drill-holes your screen has, then choose the corresponding screws.
DANGER TO LIFE!
10/13 00028309.DOC, Version 1.0