2-20 Included Weight Kit Installation
Installation Instructions For All Tank SZ Models:
Refer to Figure 2-20a & 2-20b.
—
Remove the front caster guard (A).
—
Remove (2) bolts (B) from mower's steering rack.
—
Slide weight clamp (C) into position as shown in Figure 2-20b. Fasten weight clamp (C) loosely with
—
mowers's steering rack bolts (B).
Slide (1) weight bar (D) per side into position from above. Each weight bar (D) should be positioned with longer
—
length vertical.
Tighten mower's steering rack bolts (B) to secure weight bars (D) with weight clamp (C).
—
Replace mower's front caster guard (A).
—
Figure 2-20a
Installation Instructions For Tank LZ Models w/ 48" Decks:
Refer to Figure 2-20c & 2-20d.
—
Remove mower's front caster guard (A).
—
Remove (2) carriage bolts (R) from backside of mower's front caster area. Keep existing nuts (B) and replace
—
carriage bolts with (2) 3/8"-16 x 1-1/4" hex bolts (C) P#(K1192) and (2) flat washers (D) P#(K0047). Loosely tighten
bolts with existing nuts (B). See Figure 2-21c for carriage bolt removal locations circled (R) .
Slide weight clamp (E) into position over loosened bolts as shown in Figure 2-21b.
—
Slide (1) weight bar (F) per side into position from above. Each weight bar (D) should be positioned with longer
—
length vertical.
Tighten bolts (C) to secure weight bars (F) with weight clamp (E).
—
Replace the mower's front caster guard (A).
—
Figure 2-20c
R
C
D
D
C
18
D
D
R
F
B
B
E
F
Please Note:
represent your mower as some parts have been
removed/hidden for visual clarity during installation.
A
C
B
B
Figure 2-20d
A
The images below may not fully
Figure 2-20a