NEC Built-In AIT User Manual page 42

Important
• Pressing the EJECT button does not eject the cartridge immediately because of the rewinding
or system information update operation. (It may take about 5 minutes.) While the LED is
blinking, this indicates the cartridge is being ejected and is not an error.
• Depending on your backup software or operating system lock, you may not be able to eject the
data cartridge in the drive by pressing the EJECT button. Eject the data cartridge from the
backup software or wait some time and retry the EJECT button. If you are still unable to eject
the data cartridge, press and hold the EJECT button for 5 or 10 seconds to forcefully eject the
data cartridge.
3
Open the dust cover.
4
Remove the data cartridge from the
slot and close the dust cover.
Important
• When the TAPE MOTION LED is lit or blinking, do not turn off the basic processing unit. This
may cause a malfunction or damage data.
• To avoid malfunction, do not transport this unit with the data cartridge installed.
• Eject the data cartridge when you are done performing a backup.
42 Built-in AIT