GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
back of the book, use a screwdriver to
loosen the screw, and then open the
battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram
inside the battery box. (For best
performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries
are recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
IMPORTANT: BATTERY INFORMATION
•
Insert batteries with the correct polarity (+ and -).
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
•
Only batteries of the same or equivalent type as recommended
are to be used.
•
Do not short-circuit the supply terminals.
4
4