Table of Contents
Advertisement
12.5 ELECTRICAL WIRING
C A U T I O N
Cable for auto swing motor
N O T E
After completing the wiring connection of the air panel, attach
the air inlet grille. Perform the attaching work in the reverse
procedure of removing. Refer to item 3 of the section
Hook the swivel of the supporting string at
the hole at the air panel. The air inlet grille can be attached from
any 4 directions by rotating it. When multiple indoor units are
installed or requested from a user, the air intake grille direction
can be selected freely.
Hole at air panel
Part
27
PMML0515 rev.0 - 03/2019
CN7
Supporting string
CN10
This motion sensor can be installed to any four corners of the air
panel. In the case of installing it to far corner from the electrical
to
plate of the unit between the motion sensor kit and the electrical
box of the unit.
After running the connecting cable, clamp the extra length of the
connecting cable by the plastic band and store it at inside the
ceiling.
CN10
Cable for motion sensor
PCB
Indoor unit wiring
connection
Wire clamp
Connecting cable
Fixing
plate
Advertisement
Table of Contents
