Regulation Mode - Parr Instrument 4838 Operating Instructions Manual

Regulation Mode

Press to advance
Auto-tuning
(Available in PID control and RUN mode)
4 groups PID modes (n=0~3). When n=4, PID control is auto regulated.
PD control offset setting
(Available when PID control is ON and Ti=0, set the value of PdoF)
Heating hystereisis setting
(Available in ON/OFF control mode)
Cooling hystereisis setting
(Available in ON/OFF control mode)
Heating and Cooling control cycle
or
(Available in PID control mode)
Control cycle setting of 2nd output group
(Available in PID control and Dual Loop output control mode)
P value of 1st & 2nd output group during dual loop output control
P value of 2nd output group = (P value of 1st output group) x
Dead Band (Available in Dual Loop output control mode)
Regulate temperature deviation value
Regulate upper-limit of analog output value
(Display when equipped with an analog output)
Regulate lower-limit of analog output value
(Display when equipped with an analog output)
4838 Reactor Controller
23