Page 1
We have 45,000 LP502030-PCM-NTC-LD-A02554 - EEMB - Lithium Battery Rectangular 3.7V 250mAh Rechargeable in stock now. Starting at $0.034. This EEMB part is fully warrantied and traceable. 00000005981LF-000 DC1979A EOS Power ANALOG DEVICES Buy Now Buy Now Looking for a discount?
Design files for this circuit board are available at http://www.linear.com/demo L, LT, LTC, LTM, Linear Technology and the Linear logo are registered trademarks of Linear Technology Corporation. All other trademarks are the property of their respective owners. performance summary Specifications are at T = 25°C...
DEMO MANUAL DC1979A operating principles cooling down some, the part will automatically resume op amp without powering the LT8300. Solder tacking (or attempt) normal operation, usually in a fraction of a wires to the C4 and C6 bypass capacitors is the most second.
Page 4
(10mV), even for a several-GΩ source bottom of the case using a back-mounted Connex resistance signal. If one desires to use the DC1979A as 112404 vertical BNC connector. Two 4-40-1/4" screws a permanent high voltage buffer unit, then the following are needed to mount the PCB to the case.
DEMO MANUAL DC1979A appenDix Figure 4 is an interior photo of the finished unit including operation. Standard adapters can be used to transform the switch and 9V battery. The translucent blue Hammond the output into a banana-plug pair that can directly attach 1593KTBU was selected so the LED would be visible during the unit to a DMM, as shown in Figure 5.
Information furnished by Linear Technology Corporation is believed to be accurate and reliable. However, no responsibility is assumed for its use. Linear Technology Corporation makes no representa- tion that the interconnection of its circuits as described herein will not infringe on existing patent rights.
Page 7
Linear Technology Corporation (LTC) provides the enclosed product(s) under the following AS IS conditions: This demonstration board (DEMO BOARD) kit being sold or provided by Linear Technology is intended for use for ENGINEERING DEVELOPMENT OR EVALUATION PURPOSES ONLY and is not provided by LTC for commercial use. As such, the DEMO BOARD herein may not be complete in terms of required design-, marketing-, and/or manufacturing-related protective considerations, including but not limited to product safety measures typically found in finished commercial goods.
Need help?
Do you have a question about the DC1979A and is the answer not in the manual?
Questions and answers