Operation - Makita ADSA01 Instruction Manual

OPERATION

CAUTION:
Do not point the nozzle at anyone
nearby during operation.
NOTICE:
Do not block suction inlet and/or
blower outlet during operation.
Blowing in general use
Recommended nozzles
—
Nozzle 13
Clean your work surfaces and floors by blowing off dust,
dirt, debris, scrap or waste in general.
Direct the nozzle towards surfaces at an appropriate
distance and swing it around to blow off entirely.
Fig.25
CAUTION:
Never blow debris in the direction
of bystanders or pets.
CAUTION:
Use personal protective equip-
ment such as a dust mask and eye protection.
NOTICE:
Remove blockages on surfaces away
before blowing operation.
Blowing in confined spaces
Recommended nozzles
—
Nozzle 3
Blow into confined spots, corners, and spaces by the
walls to dust off.
Point the nozzle straight at spaces at a reasonable distance
and squeeze the switch trigger to control blowing air volume.
Fig.26
Fig.27
CAUTION:
Keep the nozzle away a reasonable
distance from blowing spots to avoid blowing up
dust into the air.
CAUTION:
Use personal protective equip-
ment such as a dust mask and eye protection.
NOTICE:
Avoid blocking the air vent holes
around the blower outlet. It otherwise may cause
sudden noise and vibrations and could possibly affect
the tool performance.
1
2
Fig.28
► 1. Air vent holes 2. Blower outlet
Dusting air filter
Recommended nozzles
— Nozzle 7
Dust filter surfaces by blowing air through one side of
the filter to the other.
Direct the nozzle on filter surfaces within a short distance and
swing it from side to side to blow dust away from surfaces.
Fig.29
17 ENGLISH